Bag 0
FROM THE ROASTERY

Brew methods.

Weigh your coffee, pick your brewer, and make a cup you can repeat.

Our house ratio

Use 16.6 g of water for every 1 g of ground coffee. Set an empty container on your scale and press tare to zero it. Weigh the coffee, then measure the water by weight. For a single cup, 15 g coffee takes 249 g water. Water used to rinse a filter is extra; bloom water counts toward the recipe total.

These are starting recipes. Espresso uses a concentrated shot ratio measured by the weight in the cup. Each guide below explains how its brewer first wets the coffee.

A white cone dripper over a mug, with water pouring from a gooseneck kettle

Pour Over

A bright, clear cup for one.

Weigh
20 g coffee · 332 g water
Water
200°F / 93°C
Grind
Medium-fine, like fine sand
  1. Rinse the paper in the cone and empty the mug. Add the grounds, level them, and zero the scale.
  2. Bloom or wetting step. Start the timer. Pour 60 g of water in a spiral to wet every ground. Gently swirl and wait until 30 seconds have elapsed.
  3. Pour slowly in circles to 200 g, then to 332 g total. Aim for the last drips around 3 minutes. If it drains very slowly, go a little coarser next time.
A glass French press with its metal plunger

French Press

A round, full-bodied cup to share.

Weigh
30 g coffee · 498 g water
Water
200°F / 93°C
Grind
Coarse, like coarse sea salt
  1. Warm the press, discard the rinse water, and add the grounds. Place the press on your scale and zero it.
  2. Bloom or wetting step. For this immersion recipe, add all 498 g of water and start the timer. Stir gently to wet any floating dry grounds. The coffee releases gas as it steeps.
  3. Rest the lid on top with the plunger up. At 4 minutes, lower it slowly without forcing it, then pour all the coffee into cups or a carafe.
An upright cylindrical AeroPress on a ceramic mug

AeroPress

A smooth single cup from a small brewer.

Weigh
12 g coffee · 199.2 g water
Water
185°F / 85°C
Grind
Medium-fine, slightly finer than drip
  1. Fit a paper filter into the cap, attach it, and stand the chamber upright on a sturdy mug. Add the grounds and zero the scale.
  2. Bloom or wetting step. Pour all the water over the grounds and stir gently for about 10 seconds. This wets the grounds in one step, so you can skip a separate bloom.
  3. Insert the plunger just enough to seal. Steep until 1 minute 30 seconds from the first pour. Move the mug and brewer off the scale and press gently for about 30 seconds.
Hourglass-shaped Chemex with a wooden collar and folded filter

Chemex

A paper-filtered carafe with a light, clean finish.

Weigh
30 g coffee · 498 g water
Water
200°F / 93°C
Grind
Medium-coarse, a little coarser than a cone dripper
  1. Open a Chemex filter with three layers against the pouring spout. Rinse, empty the carafe, add the grounds, and zero your scale.
  2. Bloom or wetting step. Start the timer and pour 90 g over the bed. Gently swirl to wet dry patches and let the bloom rise and settle for 30–45 seconds.
  3. Pour in slow circles up to 300 g, then 498 g total. Keep the spout air channel clear. Let it drain for a total brew time of about 4–5 minutes, then lift out the filter.
Espresso flowing from a portafilter into a small cup

Espresso

A concentrated shot measured by what lands in the cup.

Weigh
18 g coffee · 36 g espresso yield
Water
200°F / 93°C if adjustable
Grind
Fine, like table salt ground finer
  1. Use a basket rated for 18 g. Weigh the dry grounds, distribute evenly, and tamp level. Lock in the portafilter, then zero your cup on a scale.
  2. Bloom or wetting step. If your machine offers pre-infusion, use its normal low-pressure wetting cycle. Otherwise start the shot directly. The machine wets the puck for you.
  3. Aim for 36 g in the cup in roughly 25–30 seconds from pump start. That is a 1:2 shot. If it runs too fast, try a finer grind. For an Americano, add hot water after pulling the shot.
An automatic drip coffee maker with a glass carafe

Coffee Maker

An everyday drip pot with a repeatable dose.

Weigh
50 g coffee · 830 g water
Water
About 200°F / 93°C at the grounds
Grind
Medium for a flat basket, a little finer for a cone
  1. Weigh 830 g of cool water into the reservoir, staying within its fill marks. Fit the filter and spread the 50 g of grounds evenly in the basket.
  2. Bloom or wetting step. Choose the bloom or pre-infusion setting if available. Otherwise use the regular cycle and let the showerhead wet the bed.
  3. Start the brew with the carafe in place. If temperature is adjustable, start around 200°F. On a fixed-temperature machine, let the brewer heat the water. Wait for dripping to finish, then swirl the carafe.
A stainless steel stovetop percolator with a clear lid knob

Percolator

A classic stovetop pot with a rich, robust cup.

Weigh
40 g coffee · 664 g water
Water
Start with cold water; use a gentle simmer
Grind
Coarse, to keep grounds out of the cup
  1. Choose a pot whose fill marks accommodate 664 g of water, or scale the recipe to fit. Add cold water, seat the stem, load the grounds loosely into the basket, and close the lid.
  2. Bloom or wetting step. Skip a separate bloom. Water rises through the stem and showers the grounds repeatedly. On the stovetop, reduce the heat as soon as you see steady pulses in the lid knob.
  3. Maintain gentle pulses for about 5–7 minutes, keeping the lid closed. Remove from heat and serve. For an electric percolator, use its automatic cycle and follow its fill limits.

Shop our coffee Get biweekly coffee tips